HELP: injector air shroud cone came off

[JShadzi at aol.com]

You guys all have a lot more energy than I do, IME trying to devise a tool can work, but often takes much longer and induces more hair pulling than doing the job right, passing this thing through your engine, or even pieces of it, does not sound like the best advice to me.  You should be able to have the IM off and back on within an hour or two.
Javad

In a message dated Wed, 25 Apr 2001  6:37:16 PM Eastern Daylight Time, "Bob Rossato" <bob.rossato at att.net> writes:

<< How about using a stiff wire, like a coat hanger or 14 ga. solid wire, and
bending a small hook on the end. Then insert it through the opening in the
end of the lower insert and hook onto the edge so you can pull it out.
There is the possibility that it will crumble from being brittle, in which
case you might be back to removing the manifold, but it is worth a try.

Bob

>
> Oh....pull the intake manifold, you have no choice....
> Javad
>
> In a message dated Wed, 25 Apr 2001 11:01:31 AM Eastern Daylight
> Time, Konstantin Bogach <kbogach at home.com> writes:
>
> << Javad,
>
> probably I explained not right but what is stuck in the head is plastic
> cone(lower insert, according to ETKA)  which is snaped onto brass
> insert(upper
> insert).
>
> Konstantin Bogach.


 >>