Inner CV joint shaft tool?

[Richard J Lebens]

I replaced the inner one first.  Pressed it on the shaft, put the
circlip half on, put the big socket over it and pressed it down again
to compress the dished washer and blindly seat the circlip.

--- John Karasaki <johkar at teleport.com> wrote:
> Hi,
> 
> What did those of you that have replaced inner CV joints use to hold
> the
> shaft while joint is pressed and the new C-clip is installed?  The
> Bently
> manual shows tool 40-204A, but is there some common tool to do the
> same?
> 
> Thanks in advance!
> 
> 
> Best Regards,
> 
> John Karasaki


__________________________________________________
Do You Yahoo!?
Make international calls for as low as $.04/minute with Yahoo! Messenger
http://phonecard.yahoo.com/