HELP--Torque specs

[Tim Penasck]

This was really helpful Phil.  Did I miss the rod bearings caps on the list
or do you refer to them as something else?
Thanks again
-Tim

-----Original Message-----
From: Phil Payne [mailto:quattro at isham-research.com]
Sent: Saturday, December 15, 2001 1:28 PM
To: Tim Penasck; Quattro
Subject: Re: HELP--Torque specs


> I haven't got the Bentley for the MC-2 engine yet.
> I need to know the torque spec for the main and rod bearings and if their
> is a specific tightening order.

http://www.isham-research.com/quattro/torque.html

Order is crossways outwards from the centre for the main bearings -
unimportant for the big ends.

--
  Phil Payne
  http://www.isham-research.com/quattro
  +44 7785 302 803
  +49 173 6242039