5000CSTQ wheel bearings

[Orin Eman]

> Can anyone tell me why I'm about to replace the 4th rear wheel
> bearing in just over a year.  I can't see anything wrong. I'm
> using SKF FW-137.

The same corner?

Circlips are in good shape?  Wheel bearing supported properly
as the hub is pushed in (should be a flat plate so the hub goes
_all_ the way into the bearing)?  No grease on the bearing when pushed in?
(Shouldn't be any.)  Hub damaged (no longer a press fit in the bearing)?
Oh, and the old favorite, car rolled around without the axle
(or at least the outer CV joint) installed?

Orin.