Delrin Drive Shaft Bearing Available

[JShadzi at aol.com]

I am in the process of designing a building a delrin center bearing.  I have successfully built and tested one on a V8 quattro with very good results.  Vibration and noise were not significantly increased.  A highquality FAG bearing presses in the ID, and is held in with a C-clip.  The stock bracket is hollowed out, the new delrin piece fits the ID, and 3 or 4 8mm bolts can be used to hold the delrin in place thru the stock bracket.

I am looking for 10 takers leaving a price of $45 for the delrin piece itself, and I can provide you with a part # for the bearing and circlip.  The bearing runs about $20 retail.  Shipping will cost a flat $5.

Please let me know if you are intersted, most of the cost is going to setup and machining.  If I can not get 10, then obvously the price will go up accordingly.

Javad Shadzi