5kcstq alignment question
Lawrence C Leung
l.leung at juno.com
Fri Feb 23 09:38:43 EST 2001
Make them do it over, Bring you Bentley, and watch them like a hawk (i.e.
don't let them just put numbers in the machine to get a printout, make
sure that they are actually adjusting the suspension to get it to spec).
And note, as Phil said, make sure they get everything to the center of
spec. The ranges are check values ONLY. This shop may end up hating you,
but you should get what you request, or your money back.
LL - NY
On Thu, 22 Feb 2001 18:57:23 -0600 Joshua Van Tol <josh at spiny.com>
writes:
>
>
>Front:
>
>Caster Left: 0.0 degrees Right: 0.79 degrees
>Camber Left: -0.78 degrees Right: -0.37 degrees
>Toe Left: 0.03 degrees Right: 0.04 degrees
>
GAH!
>Rear:
>
>Camber Left: -0.47 degrees Right: -0.20 degrees
>Toe Left: 0.04 degrees Right: 0.04 degrees
>
>Near as I can tell, the audi spec is:
>
>Front:
>
>Caster: +1 degree +- .6666 degrees Max difference between sides 1
>degree.
>Camber: -0.5 degrees +- 0.5 degrees Max difference between sides 0.5
>degrees.
>Total Toe: .0847 degrees - .1666 degrees
>
>Rear:
>
>Camber: -0.25 +- 0.25 degrees max difference between sides 0.5
>degrees
>Toe at each wheel: 0.0833 +- 0.0833 degrees
>
>So, the question is, did they do okay, or should I go back and ask
>them to do it over?
>--
>Joshua Van Tol -- josh at spiny.com
More information about the quattro
mailing list