CGT clutch R&R parts list

[Huw Powell]

> Ramps are out of the question because you need to pull the driveshafts to
> pull the tranny. 

only the inner ends - undo them and let them hang, the frt suspension
will stil be "located"

> Putting the car up on jackstands seems the way to go, but
> will it provide enough clearance? 

the "tall" (24", 3 ton?) ones should be enough.  the little ones might
be a bit tight.

>Also, where is the best place to locate
> the jackstands?

on the floor under the car

> A part of the procedure mentions "lifting" the front of the
> engine, which I guess is to angle the tranny downward to allow for easier
> removal. I do not have the Audi tool to do this, so what else would work?

Your jack with some wood spacing material should be ok.  Just be careful
what you push on that you don't hurt nuttin.

-- 
Huw Powell

http://www.humanspeakers.com

http://www.humanthoughts.org