quadlight setup on 4kq having problems

[Lawrence C Leung]

Are you sure? I don't recall (it's been quite awhile) having to switch
pin-outs on any of my DOT quad to H4 conversions (three so far), but I do
recall having to do a little trick to make the H1 physical pin
configuration work. Since H1s use to perpendicular prongs, (bad ASCII
art):

--   |     as opposed to US high beam   |     | 

I just used appropriate sized spade male and female connectors and some
14 ga connecting wire to make jumpers. 

Incidentally, it is possible that one or more of Sohaib's lights may not
be grounding properly, so the grounding route is through the high beams.
Didn't think of that in my previous post.

LL - NY

On Sun, 14 Jan 2001 08:45:26 -0500 "Jack Gagnon" <bullitt at cybertours.com>
writes:
>You have to change the pin-out when converting to H4's.
>
>Here is a linke to the correct pin-out.
>
>http://catalog.com/susq/other/genlamp.htm
>
>Jack
>
>-----Original Message-----
>From: quattro-admin at audifans.com 
>[mailto:quattro-admin at audifans.com]On
>Behalf Of Muhammad Sohaib Bukhari
>Sent: Sunday, January 14, 2001 5:44 AM
>To: bergerae at ifsna.com
>Cc: quattro at audifans.com
>Subject: quadlight setup on 4kq having problems
>
>
>Hi
>  I just "upgraded" to the H4 lights, while retaining the quad light 
>setup 
>on my 84 4ksq. Now the problem is that on low beams the high beam 
>lights 
>light up partially. They is also a glow of "high beams" light on the 
>dash.
>Any BTDT's?
>
>Thanks
>Sohaib
>84 4ksq
>
>
>_________________________________________________________________
>Get your FREE download of MSN Explorer at http://explorer.msn.com