shifter boot

[Konstantin Bogach]

Chris,

remove center console side panels (carpeted, one screw each).  You will see 8mm
hex head nuts, one on each side, which fix boot frame to the central console.
Slaken or remove nuts,  place the boot properly and tighten nuts. I may need to
use screwdriver to make space for boot to sit properly.  Do not push hard boot in
because it is just plastic.

Konstantin Bogach.


>
> Message: 4
> Date: Mon, 16 Jul 2001 11:32:26 -0400 (EDT)
> From: Chris Covington <malth at umich.edu>
> To: <200q20v at audifans.com>
> cc: <quattro at audifans.com>
> Subject: shifter boot
>
> All,
>
> Since I got the 200q20v back, I've noticed that somehow the shifter boot
> and square mounting part got pulled up.  I can realign it and get it to
> sort of line up and snap in, but only one side of the boot (the right
> side) seems to say attached and the left side just lays down and then
> gets pulled up later after a few shifts.  What's the proper way to make
> the boot stay on?
>
> Chris
> '91 200q20v
>