quattro digest, Vol 1 #1814 - 15 msgs

[Konstantin Bogach]

Nate,

yes, I am changing all pieces there.  I have just a problem with strut bearing because I want to change them but I
don't want to remove struts. Removing them would hurt  common sense of mine because I just replace everything in front
except strut inserts 2 weeks ago.
Could you recall how you fix those el-cheapo compressors on the spring?  Where were the turning bolt head: at the top
or at thebottom?  Did you place it between the  top and bottom coils (I mean where it is possible to grab) or just
between three coils at the middle of the spring?

Thank you.

Konstantin Bogach.


Nate Stuart wrote:

> Jumping in a little late here, but....
>
> I was able to change the shocks, springs and bearings on the bro's '87 5ktq
> w/o removing the lower portion of the strut. I too had the el-cheapo style
> spring compressors, they barely did the job. Had to wrestle the spring out
> (after taking the shock out first, and removing the tie rod ball joint from
> the spindle arm) ifI recall, the lowering springs went in much easier.
>
> While your in there that far might as well get new springs, shox, bumpstops,
> oh and some new dust boots as well.....
>
> As far as dorking up the alignment goes I just spray painted around the top
> camber plates before pulling them off to remove the shock cartridges. This
> way when you re-assemble it all it's much easier to get things back close to
> where they were.
>
> Take care,
> -Nate
> '89 90q
> '87 5ktq (donor)
> '86 5kt (donor, sorta)
>
> On Tuesday 17 July 2001 00:05, Konstantin Bogach wrote:
> > Huw,
> >
> > 200tq has a plastic bearing between upper spring support and adjustable
> > cumber plate. Thin plastic bearing.  The question is how to get that room?
> > Can I compress spring enough with el' chipo spring compressors I have?
> > (most simple ones).  I tried to imagine how it works and I have some
> > doubts.
> > If I place turning nut at the top coil then I don't have rom for wrench to
> > turn it. If I turn it over then moving up rod will touch against tower top.
> >  But I did not try though. Just thought.
> >
> > Konstantin Bogach.
> >
> > Huw Powell wrote:
> > >Something...
>
> --__--__--
>
> _______________________________________________
> quattro mailing list
> quattro at audifans.com
> http://www.audifans.com/mailman/listinfo/quattro
>
> End of quattro Digest