speedo disassembling: need help!
Konstantin Bogach
kbogach at home.com
Sat Jun 23 12:32:00 EDT 2001
No, I am not stupid. I just need to read what I have typed befor I send it. It is
about "fuel tahometer".
My concern is that if I need to take off that big board from the assembly then I have
to remve some jumpers and maybe something else. Jumpers are special in the way that
they have wire hooks at the bottom to grab the board. I did not know about that and
when I pulled one I was scared that I broke something.
I am not sure that part I should remove and what parts can be removed w/o damaging
the cluster.
I will appreciate your help.
Konstantin Bogach.
Konstantin Bogach wrote:
> Sorry, I meant fuel tahometer, not odometer. But actualy, I should've asked about
> fuel gauge.
>
> Konstantin Bogach.
>
> Konstantin Bogach wrote:
>
> > Tony, list
> >
> > I need some help on instrument claster disassembling. I am afraid to break
> > something.
> > I took off hinged cover with PC board. I took off plastic housing. What is left
> > are gauges mounted on white thick plastic plates and these plates are attached
> > to some board which looks like bigest PC board in the cluster (the board into
> > which bulbs are inserted). There are some small boards are fixed here and
> > there on this big board. Like board onto which LCD is attached (shall I remove
> > this small board to service some contacts?).
> > What is main board there? So far I don't see square contact posts. Shall I
> > detach temp gauge and odometer?
> >
> > Konstantin Bogach.
> >
> > Tony Lum wrote:
> >
> > > At 10:53 PM 6/20/2001 -0400, you wrote:
> > > >Hi listers.
> > > >
> > > >I took dash off to get better access to instrument panel connectors. I
> > > >have not idea how people could disconnect those connectors without
> > > >removing whole dash! But anyway, it is 2 hours job if you do it 1st
> > > >time(but know what to do).
> > > >I do it cause speedo jumps plus-minus 10mph. I have no idea what might
> > > >be the reason but I had time while I wait for new rear control arm to
> > > >come. I am thinking about cleaning connectors and checking soldering in
> > > >the place shown on SJM site.
> > > >Can somebody add something else?
> > >
> > > Hi Konstantin,
> > >
> > > I just repaired my mother's 100 Avant with a similar bouncing
> > > speedometer. You must disassemble the instrument cluster to get to the
> > > speedometer where it plugs into the main circuit board. I resoldered all 4
> > > connectors, scrapped the square contact posts on the speedo unit and
> > > sprayed DeOxit5 into the molex contacts and inserted the speedo and moved
> > > in and out about 5 times. Works like a champ now.
> > >
> > > HTH,
More information about the quattro
mailing list