200 TQ Dash Panel removal

[Kneale Brownson]

There's a screw that holds both the bottom left of the panel (looking from 
driver seat) and the bottom of the side panel at the end of the dash.  With 
that screw out, you can pull the end panel off (push up slightly and pull 
out lower edge, then slide it down).  Behind the end panel there are two 
screws that help hold the underdash panel in place.



At 04:51 PM 03/10/2001 -0500, Kent wrote:

>OK listers, here is a question that will expose me as a Monkey Lad.
>I'm trying to get to the Aux. Relay panel to jumper the headlight warning
>light so my Euro headlights don't cause the "burned out bulb" warning.
>
>In trying to access the panel, it seems I have to remove the panel below
>the steering wheel to gain access. I've got two fasteners removed -- one
>on the bottom right and one on top under the steering wheel. But the panel
>is hung up on the left, near the door jamb. I'm sure there is a fastener in
>there somewhere, but for the life of me I cant' see it.
>
>Q. How do I get to the nut/bolt/screw on the left that is holding the trim
>panel?
>
>Humbly yours,
>Kent McLean
>'89 200 TQ
>
>
>