[urq] Re: wheel studs - better check the length!

[John Corbishley]

Valid point.  I came up with the 40mm stud after a fair amount of trial and
error.  If anything it will be too long for my app with the SQ rotors by a
couple of mm.  This means it will be 0.5" too long for regular UrQ rotors.
Unfortunately the 40mm is the shortest that H&R makes.  One could obviously
cut them.

The thread portion that screws into the hub is fine and will not foul
anything.

John Corbs

----- Original Message -----
From: "Fundsalo Racing" <fundsaloracing at yahoo.com>
To: "Kneale Brownson" <knotnook at traverse.com>; "John Corbishley"
<jcorbs at gtresort.com>; "Penasack, Tim" <Tim.Penasack at storagenetworks.com>;
<one at humanspeakers.com>
Cc: "'urquattro'" <urq at audifans.com>; "Quattro List" <quattro at audifans.com>
Sent: Tuesday, May 15, 2001 2:43 PM
Subject: Re: [urq] Re: wheel studs - better check the length!


>
> On the swapping about of wheel lug bolts.... They may
> 'fit' fine, but be sure they are of the correct length
> for the wheels you are using! Too short and they may
> pull out and you could lose a wheel :(  (saw two of
> these, one Audi, one VW at my last track event) or too
> long and they might interfere with something behind
> the hub.
>
> -glen
>
> OOOO
>
>
>
> __________________________________________________
> Do You Yahoo!?
> Yahoo! Auctions - buy the things you want at great prices
> http://auctions.yahoo.com/
>