euro light install need help fast

[Brendan]

You'll also need brackets. Believe me, you'll need brackets (from a Euro
4k/90). I got mine from my good friend Iain in England and they fit right
up to the headlight hole, and hold the light. They can be attached with
fender screws or the N 013 968 1 called for (4x a side). The US bracket is
811 941 117 and 8, but this is for standard US dot headlights. You can
attach a nifty side piece to this bracket to "fit up" something that will
work for the top. The euro version I refer to looks like the US version,
except for a curved piece on the side and little "ledge" that attached the
top piece to the body.

Hope that helps,
Brendan

At 09:03 PM 11/5/2001 -0500, Huw Powell wrote:
>You need a set of good old sealed beam connectors for the H4's, though
>the wiring is slightly different.  FLAPS will have these with short
>amounts of wire attached for replacing old ones, should be around $5
>each.  Your H1's will have to be "tapped" off the high and ground wires
>going to the H4, basically.
>
>And of course your relay system will accomodate whatever level of
>complexity you wish to design in, for special features, higher power
>bulbs, etc. and either complicate or simplify matters.
>
>Luke Rickert wrote:
> >
> > I am trying to install some used h1/h4 euro lights in my 87 4kq. I got the
> > old lights out, but the new lights have very different attachement points?
> > do I have to make some new brackets or what?
>
>--
>Huw Powell
>
>http://www.humanspeakers.com/audi/
>
>http://www.humanthoughts.org/