K-26 cold side backing plate bolts (RIBE) ???

[TM]

I was informed by Konstantin that the bolts are not triple-square,
I apologize for any misinformation to listers reading this dialogue.

I'm not going to argue semantics here- my comment is in the context
of a properly trained professional mechanic who takes pride in his/her
work and does a job properly will always use the correct tools and make
sure that the tools are on hand for the job rather than to use something
that "sort of fits" or "is close enough."

You want to pick at every single word, fine. It doesn't address the
point that you should always use the proper specified tools for any
job if you want to do it right, it merely underscores your lack of
ability to have a civilized discussion in a meaningful context.

Taka