DIY Turbo using diesel bits?

[Tom Nas]

"Brian Mole" <mole at ntlworld.com> wrote:

>Splendid stuff, thanks Mike et al, I think I'll buy the bits as it's a bit
>too good to miss.
>Some further questions: The JT code you mention does not appear in the web
>resources I have, can you tell me the capacity and compression ratio? I
>used 7psi
>on my Ford against a CR of 9.5:1, but it pinks under load.
>Also, Jim Haseltine has been helping me with stuff about my strange KU
>engine (TY, Jim)
>but I'll be needing access to part numbers without imposing on listers all
>the time,
>where do I get this ETKA thing? Failing that, can someone tell me the
>capacity and
>CR of the KU (the web sites vary between 2226 and 2309, Haynes says 2226 and
>German and Swedish says 2230!).

ETKA says 2226, 136 hp, installed in type 44 Audi 100/200.

Tom