Crank pulley again... does this look right?

[Gerard]

Sorry folks, being a complete newbie on this topic. I've done a test fit
of the new crank pulley to the damper and noticed a few things:

1. No spring washers fitted to the cap screws (I posted
   another message about that)

2. The inner ridge of the new pulley is alot thicker than the old.
   The picture below shows how the fitting guide stands way clear
   of the damper and you can see the unpainted mark where the old
   pulley used to sit flush with the damper. Anything to worry about?

pic: http://64.176.6.234/images/crankpulley.jpg

Sorry, being very stupid with all this. First time doing stuff like this
and don't want to bugger things up (anymore than I have, that is :)).

Thanks.

G.