type 44qt engine mount cooling duct location

[Brett Dikeman]

At 2:35 PM +0100 4/10/02, Graham Thackrah wrote:
>Hi all,
>
>I have a new engine mount cooling duct and can't find where to fit it near
>the engine mount. The front end has a piece of sprung wire to hold it near
>the oil cooler duct but the rear of it doesn't seem to have any logical
>place to sit - there is no complementary bit of sprung wire for it back
>there on my car, should there be one? I can't check the old duct cos there
>ain't one...
>
>My only clue was a screw on a bit of sheet metal that had remnants of the
>same type of fabric the new duct is made of behind it, but it didn't look
>like it would aim the duct to have any cooling effect.

One end goes into the oil cooler, the other goes onto the funny
shaped shield on the mount itself(or around it.)

Brett
--
----
"They that give up essential liberty to obtain temporary
safety deserve neither liberty nor safety." - Ben Franklin
http://www.users.cloud9.net/~brett/