Idle speed too low

[Huw Powell]

> I finally got the
> motor back in and running a few days ago, but to my dismay I can't get it to
> idle right.  The engine will stall out unless I keep my foot on the
> accelerator.  I was expecting this to happen after replacing the
> gaskets/repairing vacuum leaks.  I've adjusted the idle and CO in the past on
> my non-turbo 5000 without any problems, but for some reason I do't have
> enough travel on the idle screw to get the idle to the proper level

>  To my knowledge the ISV is working OK

well, it may be good, but it is not working.  The ECU would use it to
try to raise the idle.

throttle body idle switch working?

--
Huw Powell

http://www.humanspeakers.com/

http://www.humanthoughts.org/