108mm to 100mm conversion....

[Ragnampiza at aol.com]

In a message dated 8/6/02 1:07:39 PM, t44tq at mindspring.com writes:

<< You'll need VW QSW hubs, but I don't know if that would
work w/ G60 calipers, because they were not used on any VWs
using that bolt pattern, and the offsets might be different.

Taka >>

the g60 won't work,you can only fit the qsw hubs to cv's w/24mm spline shafts
I believe the g60 require a 5x112 hub that fit to cv's w/28mm spline shafts
and if you have 28mm cv's and you want to change to the 24mm type you'd have
to
start with the 28mm cv's that use 17mm balls.If you have 28mm cv's that use
the 22mm balls...you would have to change to the proper axle that takes the
28mm outer cv's with 17mm balls.

the 24mm shaft will take
4x108
4x100
5x100 eurospec....don't know if there is a special rotor and caliper mounts
for this setup but I doubt it

In any case all this is going weaker not stronger