108mm to 100mm conversion....

[Ragnampiza at aol.com]

In a message dated 8/7/02 3:50:49 AM, Ragnampiza at aol.com writes:

<< you would have to change to the proper axle that takes the
28mm outer cv's with 17mm balls. >>

clarification:
start with above and pull outer cv and replace with 24mm shaft unit

then depending on which bearing
443 498 625
   WHEEL BEARING KIT-REAR-With Hardware
      88 Only   80/90 Quattro 5 Cyl. - Thru Vin: 89-J-350000 - 10 Valve
these are for 28mm shafts they are 75mmx43mmid


893 498 625D
   WHEEL BEARING KIT-REAR-With Hardware
      88-92     80/90 Quattro 5 Cyl. - From Vin: 89-J-350001 - 10 Valve
don't know what these are but unless they're 40mmid plan on custom bearings
with 40mm id for your changover. QSW hubs are 40mm OD