97 A6Q rear brakes
Aalok Kacha
aalok at uchicago.edu
Mon Aug 19 13:41:44 EDT 2002
I hadn't looked at it closely, but I've been using one of the other faces
which works OK on my car, but I can see that the 4 corner one will be a much
better fit. I'll grind 2 of them down and use it next time. I have a '98 A4.
--
Aalok
On 8/18/02 2:30 PM, "Kneale Brownson" <knotnook at traverse.com> wrote:
> --
> At 12:04 PM 08/18/2002 -0700, CL Wong wrote:
>
>> the lisle tools needs to be modified to fit our cars.
>> See bentley for the procedure. Basically, you need to
>> grind off 2 corners of a 4 corner side of the tool
>> that is the closest match.
>
> As someone pointed out to me when I touted the Lisle-type tool a while
> back, this approach is only marginally successful unless you have like-new
> pistons in perfectly-performing calipers. If you need to apply much of any
> force to get the piston to retract while turning it, the little square
> block with the tiny prongs is a sure way to skin some knuckles. The tool
> worked fine on my 200q20v's rear calipers that were on our salty roads less
> than a year, but when I tried to use it a few weeks ago on the V8, which
> probably has the original calipers, it was a flop. I'd of almost paid the
> $60 or so for an "official" tool if I could have walked in and bought
> it. Instead, I used the water pump pliers and C-Clamp approach.
> --
>
More information about the quattro
mailing list