Was: Wiseco piston job number - max oversize for 10V motors?

[JShadzi at aol.com]

--
[ Picked text/plain from multipart/alternative ]
You can safely bore any of the I5 blocks to 83+mm, BTDT up to 84.

Javad

In a message dated 8/22/2002 10:17:41 PM Pacific Daylight Time,
antar at attbi.com writes:


> thanks a lot for the job number. so, that's pretty close clearance for a
> forged piston..closer to the JE's. btw, are KH and MC blocks the same
> castings? My bores are at 3.13" now. The MC is 3.19" stock, and it seems
> the Wiseco's are 3.25", which would be a .120" oversize for my block. I
> just hope the water passages aren't in the way. Anyone have any advice on
> the max bore size for all the 10V  motors? Thanks again.
>
> -ameer
>