transverse/camber link - Control Arm for 89' 200q wagon

[Dan Dwyer]

Thanks Ben and others for the info,

I just wanted to make sure there wasn't a $20.00 solution before plunking
down $115.00 per side.

-Dan

> Dan,
>
> It is called the Transverse Link or Camber link.  They are available
> from thepartsconection and/or force 5 for reasonable $.
>
> You can not separate the ends by conventional means without damage, and
> it is not available that way AFAIK.  Just get the assembly - you'll be
> glad you did.  If one side is going, the other will be sure to follow,
> so do both.
>
> Oh, I recall you need to torque the hole end when car is on the ground
> to prevent premature failure.
>
> Ben
>
> [Hello,
>
> Does anybody know if you can get just the tie rod end circled in the
> link below:
>
> http://www.eecs.wsu.edu/~ddwyer1/temp/controlarm.jpg
>
> or even the bushing that goes in the tie rod end if it exists.  If they
> are available apart from the whole arm, where at and for how much?
> I've looked around the archives with little success, probably due to my
> sketchy understanding of all of the part terminology.
>
> TIA,
>
> -Dan]
>