In-situ flywheel timing pin replacement
Joshua Van Tol
josh at spiny.com
Mon Dec 23 13:18:50 EST 2002
On Monday, December 23, 2002, at 11:27 AM, Jpinkowish at aol.com wrote:
> In a message dated 12/23/02 12:19:53 PM EST, ackramer at hotmail.com
> writes:
>
>> epoxy a roll pin to the pin stub and shim the
>> sensor back by the thickness of the roll pin.
>
> how about using J-B Weld or Loctite Cold Weld instead of the epoxy?
>
Don't know about the loctite stuff, but jb weld is just metal loaded
epoxy. Pretty good metal loaded epoxy, but not unique.
More information about the quattro
mailing list