Replacing Master Cylinder 5KCSTQ, update

[james accordino]

They take a clean worn MC and line bore it about 2-5
thousand over and use custom seals that are similarly
oversized.  This somewhat compromises the MC but they
feel an overly large seal clearance will still hold
the pressure.  Hey, I'm not an engineer.

Jim Accordino

--- Kneale Brownson <knotnook at traverse.com> wrote:
> How do you reman an alloy MC?  I didn't think anyone
> rebuilt MC's unless
> they were cast iron.
>
> At 04:02 PM 02/20/2002 -0800, james accordino wrote:
>
> >That's super cheap for a MC.  Do you have a Napa
> P/N?
> >
> >Jim Accordino
> >
> >--- Erik Gerrits <erik_gerrits at yahoo.com> wrote:
> > > MC cost $43 for a reman from Napa I figured that
> I
> > > would replace it to take it out of the equation.
> > > Thanks,
> > > Erik Gerrits
> >
> >
> >__________________________________________________
> >Do You Yahoo!?
> >Yahoo! Sports - Coverage of the 2002 Olympic Games
> >http://sports.yahoo.com
>


__________________________________________________
Do You Yahoo!?
Yahoo! Sports - Coverage of the 2002 Olympic Games
http://sports.yahoo.com