[urq] Help - Replacing hydraulic tappets/lifters

[Mihnea Cotet]

At 14:58 8/01/2002 -0500, QSHIPQ at aol.com wrote:
>This thread needs some clarification.  On a 10vt 200q (all 10v audi motors in
>fact), you *cannot* change the lifters without removing the gear wheel,
>because the rear cover will prevent you from doing so.  You could cut the
>cover I suppose, but the cam bolt isn't that difficult.  Given this is a UK
>post, I'm sure Paul is referencing the 3B equipped 89 200tq available in
>europe only.

Heh, the 200q20v has never been available to the UK market....you should
read more thoroughly Phil's posts :)))
And I think he has a 2.2l KU engine, pretty similar to the CGT's KX, just
more compression and plain old CIS with no OXS.

Mihnea