Air fuel Stoich gauges

JShadzi at aol.com JShadzi at aol.com
Wed Jun 26 17:06:33 EDT 2002


Mike, it doesn't sound like you have everything connected properly, ensure that you are in fact using the black signal wire from the O2, you should have a signal on the gauge at all times. Also, where did you say you have the sensor installed, on your exh. manifold??

Javad


>A question for others who have installed 02 and A/f gauges into their UrQs
>or turbos.  I am running a heated 02 sensor along with an Autometer A/F
>gauge.  02 installed in main tube of 2 pc manifold. My question is do other
>with a "similar" setup get readings at all times?  After warm up, I only get
>readings during acceleration or deceleration.  AT warm idle I have no
>reading, blip the throttle and a quick reading.  At cold start I have
>readings with a regular drop from rich to stoich to lean then nothing until
>acceleration.  I originally ran a single wire 02 and chalked this up to the
>sensor cooling off, so I went with a heated 02 sensor, (Bosch is offering
>$10 off 02 sensors through the end of the month, generic 3 wire currently
>$29 before rebate) Ideas?  Also WOT shows rich, but not show full rich, I
>can adjust this, but wonder what others have done.
>Thx
>Mike 81 UrQ
>
>
>
>_________________________________________________________________
>Send and receive Hotmail on your mobile device: http://mobile.msn.com
>
>



More information about the quattro mailing list