Need verification 80/90Q clutch disk and pressure plate with ??? disk for 4kq

[Ben Swann]

Javad,

I have a very nicely done lightened 90Q flywheel that is worthy of finding
the right combination.  I knew that the 90q disk had a different number of
splines, but didn't realize how different the setup is  until I had it in
my hands.

The 200 pp and disk mate up just fine, but the depth of the 90q with the
200 pp is about 1/4" more.

I suspect the 90 flywheel should work fine with a 90 pressure plate (duh).
 What I need to confirm is that the 200 or 5000 disk is the same dimension
or fits properly when all bolted together.

If anyone can confirm this is a valid setup, then It will save me some
aggravation:

NG engine with 90Q flywheel - 200 clutch disk - 90 q pressure plate - 4000Q
transmission.

TIA,

Ben

On Thursday, March 07, 2002 4:45 PM, JShadzi at aol.com [SMTP:JShadzi at aol.com]
wrote:
> The 01A flywheel is very different, but you might be able to make it
work.  I know the splines are different, so the 80 disk won't work.  PP
should be ok.  Also, the 01A flywheel will take either a 228mm or 240mm
disk, no need to go 240 unless you think your gonna make 200+hp.
>
> Javad
>
> >
> > I am test fitting to find the right clutch combination -  trying to
mate up a lightened 90 Quattro flywheel to a 4000quattro trans.  Does
anyone have a
> > used 80 or 90 Quattro pressure plate and clutch disk they can send me.
 I
> > don't know if there were any breaks in sizes, but the flywheel I am
using
> > takes 240mm disk and pp.
> >
> > TIA
> >
> > Ben