Seat heater repair success?

[Wayne Dohnal]

>One could make some resistance measurements with an
>Ohm meter on a repaired section compared to an
>unbroken section of the same length. I would  think
>they should be within a a couple 100 ohms of each
>other.
>
 >-ed

I'd hope they are this close, because the resistance of a good
new-generation (i.e. copper wire) element is 1.2 ohms.  My repair experience
was that I fixed a break, and after about 15 minutes of use it burned out in
another spot.  Fixing the element is pretty easy, but getting to it is just
too much work, so I'm going with a new element.

Wayne Dohnal
1994 S4