Yikes: Wheel Bearing Puller Kit $386!

[Eric_R_Kissell at email.whirlpool.com]

On 3/21/2002 Donald Lamond <dlam119 at bellsouth.net> wrote:

>Do you have any photos or measurements of the tool you made?

Not yet. 
I may be able to measure things and maybe take a picture this weekend.

I sized things to fit starting from measurements that were in the ballpark. 
If I remember correctly, I had neglected to measure the shoulder in the 
hub, so when I sized the puller using an old bearing it ended up too large 
and I had to take a bit more off. 

I will see if I can work it in this weekend.

Eric Kissell
-------------- next part --------------
begin:vcard 
n:Lamond;Donald  
tel;home:919-416-9869
x-mozilla-html:FALSE
adr:;;;;;;
version:2.1
email;internet:dlam119 at bellsouth.net
fn:Donald Lamond
end:vcard