the damn thing SNAPPED! [was: Re: pressure plate bolt torque? ]

[James at ringsperformance.com]

The flywheel bolts are wet with engine oil; use loctite or some sort of
sealer on them or your clutch won't last five minutes.
cu, James Marriott
'84 4kq beater, 217k, for sale (BUY IT!)
'87 4kq (alias "late-B2 90q") with rare ersatz NG engine, 184k
'89 200q (MC1, ProconTen/no bag, 1.8 blah blah), 142k
Boise, ID, USA     http://www.webpak.net/~marriott/
www.ringsperformance.com
----- Original Message -----
From: <auditude at get.net>
To: <quattro at audifans.com>
Sent: Wednesday, March 27, 2002 9:44 PM
Subject: Re: the damn thing SNAPPED! [was: Re: pressure plate bolt torque? ]


> Huw,
>
> I think you called it.  I have the older, single book Bentley.  I can
> see that the stupid torque spec for the center bolts says only 18 ft
> lbs, with an arrow pointing to the bit bolts for the flywheel.
>
> The Bentley has an arrow pointing to the little allen bolt I broke,
> and lists the information I posted.
>
> Looks like my Bentley is broken.  Damn thing.  That's the last time I
> buy a used obsolete Bentley off some local dude. :-)
>
> Had I studied the whole page, I would have seen the typo.  Duh,
> shouldered vs. non-shouldered makes a helluva lot more sense for
> those bolts.  I've yet to see a shouldered allen bolt.
>
> Well, I guess it ain't so back.  I think I probably undertightened my
> center bolts, so it's all good that I didn't try to drive that way.
> Not to mention put it back together to have to take it apart again.
> One 6 month clutch job at a time, please. <g>
>
> Damn.
>
> Thanks!
>
> Ken
>
> On 27 Mar 2002 at 23:20, Huw Powell wrote:
> > >
> > > As I feared as I was turning it, the FREAKING BOLT SNAPPED!
> >
> > I think someone is mixing up flywheel to crank bolts - fat, short,
> > shouldered ones in a snmall circle, and the pressure plate to flywheel
> > bolts, little baby allen head ones around the outside.  But I don't know
> > who... or how... or when...
> >
> > > >     You should use the new shouldered type bolt, this means there is
a built
> > > > in washer cast into the head of the bolt.  You've seen a shouldered
bolt
> > > > before most likely, it has a regular hex head on it, but also flairs
out to
> > > > form a built in washer, all one piece.  The flywheel bolts are
stretch so
> > > > don't reuse, some have reused, but safety wise I have always gone
with
> > > > replacing them.  If you got new bolts from the dealer, which you
should,
> > > > then use the shouldered bolt spec.
> ------- End of forwarded message -------
>