CV Boot 80q

[Huw Powell]

> You don't want to use screw type hose clamps to secure the boots.  Not only
> are there clearance issues, but you'll cause an unwanted imbalance, however
> minor.

> Ok, so whats the technique to tighten these?  Any special tools required?

Yes, there is a special plier thingie that tightens the ring while
crimping the closure.

> How bout "wire-ties"?  They're good, right?  And cause
> they're plastic, they don't rust.  They even come in
> colors.

while I think they'd be good to get the car somewhere that the proper
ring can be clamped on, I would worry a tiny bit about the fact that
they never quite close with pressure on the full 360 degrees - there's a
small gap at the "tie up" point, grease could escape, grit could get in
- maybe.

I used a zip tie when I discovered my new rack's sealing clamp had
"vanished," until I could bring it next door and fix it properly... uh,
I *think* I fixed it properly, anyway...

--
Huw Powell

http://www.humanspeakers.com/

http://www.humanthoughts.org/