Removal of clutch slave cyl

[Steven Sprague]

Just a tip on the hammer, we used a Snap-Off hammer with sand in the head which will magnify your force when hitting the punch.  Do make sure the punch is the same diameter as the roll pin.  Take the wheel off too, that seemed to
help. Plus I had someone hold the punch for me, watchout for those fingers!, while I hammered away!  I caught my friend a few times...He's still my friend after that.

Hth,
Steve

Britt Crowell wrote:

> This is a multi-part message in MIME format.
> --
> [ Picked text/plain from multipart/alternative ]
> Ok, I messed with it, cant get the roll pin to even budge, the locak shop want about $200 to do it.
> My last though was to drill out the pin and replace with a bolt. Think I'll screw anything up?
>
> I cant get a good wack at the damn roll pin, how ever I have not take off the wheel to get at it yet. and words of encouragement or should I just spend the 2hung? And winter just showed up here in Colorado and it got COLD!!!!
>
> Britt Crowell
> Crowell Consulting Inc.
> 970-484-4995
> --