200q20v springs on 200q10v?

William M. Lockwood-III wlockwoo at zoo.uvm.edu
Thu Oct 31 10:20:08 EST 2002


Eyvind,
I have this combination on my 88 5000tq.  I bought 200 20v H&R springs for the
car when I couldn't find springs for my 5k.  Apparently they are about 20mm
lower and 20-30lbs stiffer than the H&R units for the 5k.  These are what I
remember from I think a guy at tire rack who was very helpful.  The springs are
fine using BOGE Progas shocks in front and BOGE Sport (very rare I think) in
the rear.  Car is very stiff and a little bouncy in the back at times.

Bill
88 5ktq, red, in VT

>
> I have a set of H&R 29800 lowering springs for 200q20v here. Can they
> be used on a 200q10v? I know they physically fit, but how will the car
> get? I think it will be as high as stock (if not higher) and very
> rough.. Or maybe not?
>
> Anyone have the spring rates for the 29800 (200q20v) compared to the
> 29616 (all other type 44 except V8)?
>
> --
> E. Spangen
> '86 Audi 100 2.2 CS quattro
>




More information about the quattro mailing list