90 tq 01A Transmission Fluid Fill Questions

[Richard Beels]

That's the traditional way, yes.  And for everyone else reading, make sure
you can remove this plug BEFORE you pop the bottom one off.

At 13:36 09/14/2002, Shakespearean monkeys danced on Christopher Flanner's
keyboard and said:
>Hello List,
>
>When replacing the driveshaft seals on my '88 90tq 01A transmission, much of
>the fluid came out.  I can't find a fluid capacity or level check method in
>my Bentley or owner's manual.
>
>I'm assuming that the procedure is to get the car level, remove the 17mm
>plug near the driver's side drive flange and fill until fluid flows from
>that opening.  Is that correct?  Does anyone know the total capacity of that
>transmission?  Please advise.
>
>TIA,
>Chris


Cheers!