[urq] Suspension problem on SQ

[Dave Glubrecht]

Do you have a web page and/or any pics of this on the web?
    Thanks
       Dave G









----- Original Message -----
From: "ccohen5" <ccohen5 at compuserve.com>
To: "qlist" <quattro at audifans.com>; "Audi S Car List"
<s-car-list at audifans.com>; <urq at audifans.com>
Sent: Wednesday, September 18, 2002 5:12 PM
Subject: [urq] Suspension problem on SQ


> The SQ has 4 radius rods that run from the front of the sub frame to the
> lower control arms and from the center of the rear body to the lower rear
> control arms.  My problem is the bushings in the rod ends have worn badly.
> The rods and the rod ends (only one rode end is adjustable/replaceable on
> each rod) are NLA.
>
> So I need to find a machine shop which will match the inner and outer
> dimensions of the rode ends and help me source replacement bushings.  This
> is not the sort of thing that shops do every day, certainly on the East
> Coast.  The Urq does not have these devices and the SQ roll bar which is
> thicker than the Urq I believe, uses large rubber bushings that also seem
to
> be NLA.  But that's another story.
>
> Any suggestions, has anyone had this sort of work done for them.  I know
> that single sweaters and many closed wheel sports prototypes use similar
> geometry but I don't know any of these shops.
>
> Thanks.
>
> Colin
>
> _______________________________________________
> Audifans urq mailing list
> Send posts to: mailto:urq at audifans.com
> Manage your list connection: http://www.audifans.com/mailman/listinfo/urq
>