FW: Hub Shark

[Livolsi, Stephane]

>  ...At this point you would only need to remove the tie rod
> end ...
>
That's a bit of an understatement, from those of us who have 'only' needed
to remove the tie rod end.... my humble experience has been that this part
of the job is absolutely the worst and most difficult and I speak from
multiple experiences on both Audi and other marques.

.02

Stephane




> ----- Original Message -----
> From: <cobram at juno.com>
> To: <passat_ts at hotmail.com>
> Cc: <knotnook at traverse.com>; <chris.perry at weyerhaeuser.com>;
> <quattro at audifans.com>
> Sent: Wednesday, April 02, 2003 1:25 PM
> Subject: Re: Hub Shark
>
>
> > "passat TS" <passat_ts at hotmail.com> writes:
> >
> > > For these prices, you can buy a press and the correct dies, or even
> > > better find the right impact wrench socket with similar diameter to
> the
> >
> > > required die, and Voila'!.
> >
> > You miss the point, the Hub Shark does the job ON the car, you don't
> have
> > to remove the strut assemblies.
> >
> > BCNU,
> > http://www.geocities.com/cobramsri/
> >
> > ________________________________________________________________
> > Sign Up for Juno Platinum Internet Access Today
> > Only $9.95 per month!
> > Visit www.juno.com
> >
>