Flywheel pins

[Jim Green]

--- blarson at Zeiss.com wrote:
> 62btdt might be a good number, assuming you use the
> correct 0 degree mark,
> which is not zero on your NG flywheel.  It is 6
> degrees off on a MC.  You
> could just scale around the perimeter 62 degrees,
> and drill your hole the
> correct distance from the edges of the flywheel
> teeth.  You need to remove
> material to clear the pin, and if the distributor is
> not within 2 degrees
> of the correct location, the car will not start.
> Here are some examples of
> the pin location removing the minimum amount of
> material.
>
>
http://www.teenaflanner.com/chris/90tq_turbo_conversion_gallery/imagepages/flywheel_correct_pin1.html
>
http://www.teenaflanner.com/chris/90tq_turbo_conversion_gallery/imagepages/flywheel_mod2.html
>

Great, that's what I need to know.

Thanks,

=====
Jim Green
'89 90tq 034EFI, Haltech IG5
http://www.geocities.com/jeg1976/car_home.html

__________________________________
Do you Yahoo!?
The New Yahoo! Search - Faster. Easier. Bingo.
http://search.yahoo.com