'89 100 Intake Manifold

[mike mcclurg]

Eric,

If they are the 6mm allen head variety, try pounding
in a 1/4" hex drive bit or allen wrench. You can then
put some pretty good torque on it. Worked for me on
the upper half of my '89 100q intake manifold when
they were stuck.

Mike
--- Eric Wulf <edwulf at msn.com> wrote:
> This is a multi-part message in MIME format.
> --
> [ Picked text/plain from multipart/alternative ]
> Hello to All,
>
> I have two stripped bolts (both lower and harder to
> get to) in the intake manifold of my '89 100.  Any
> suggestions/tips/tricks?  I've got a small set of
> screw extractors, but I'm not sure I could
> effectively use it in this case, considering the
> space and angle involved.
>
> Thanks in Advance,
>
> Eric Wulf


__________________________________
Do you Yahoo!?
Yahoo! SiteBuilder - Free, easy-to-use web site design software
http://sitebuilder.yahoo.com