Symphony 2 install in non-Audi?

[David Eaton]

----- Original Message Follows -----
> From: Ti Kan <ti at amb.org>
> Subject: Re: Symphony 2 install in non-Audi?
> To: Walt_Helsel at URSCorp.com
> Date: Sat, 23 Aug 2003 09:34:44 -0700 (PDT)
> Cc: quattro at audifans.com (Audi Mailing List)
>
> > > I'll include the connection description for the older
> > > Delta CC and the Concert I/Symphony I radios below.
> > > The Symphony II is only slightly different than the
> > > Symphony I, so hopefully that will help you get things
> wired up correctly. >
> > ***** I overlaid it on the Symph II pinout I found,
> > check here:
>
http://www.gravitydesign.net/saturn/yellowsub/images/SympII_Labelled.gif[1]
> > Do I have the pins laid out correctly?  Looks like the
> > major changes are Black 1,2 and 4 and that's it?
>
> Yes, those are it.  I am not sure pin 6 on the Symphony
> II's black connector is for illumination, since it was not
> labeled as such. I am not sure that the CAN bus signals
> are the same between the Symphony II and those for the
> earlier radios (you may also have the pins labeled wrong).
>  Lastly, pins 9 and 10 on the 10-pin connector may not be
> the same between Symphony II and the earlier radios.
>

can wiring is not to the black connector, can connections
are to the 6-pin green connector (i.e. within the generic
20-pin connector whcih  is actuially a 8-pin blue
(cd-changer), 6-pin green (can) & 6-pin yellow
(bose/amp.speakers)).

on the symphony ii, only 4 wires are used to the black
connector.  1, 3, 7 & 8.  3 is the "k" wire which is also
used for switched power, 1 & 8 are ground, and 7 is battery.
 i have heard that switched power can also feed into
connection 2, by it is not used on the s8.

hth
dave
'01 s8