Part # for strut Bar??

[Huw Powell]

> Cool. Thanks. I want it for my CGT.
> The "air duct" is $34.95. Exactly the cost you show for the bar, Huw.
> Looking at the pictures, it strikes me that it may be nothing more than a
> length of 3/4" square stock. If so, I could get it at Home Depot for less
> than 1/3 the cost i would think (I gots plenty of paint). Although I'd still
> need to buy the connecting bits.
> Anyone care to measure the cross-section dimensions, and length for me?

Just buy the end pieces and work from there... and if it's metric and
you can't sub in a piece of "cheap" steel, then buy the Audi part.

Oh, ok, I'll outside and measure it... after this auction is over...

Hmm, seems to be 3/4" by 3/4" OD, about 37 1/2" long.  Although there is
a chance there is "something special" about the factory part, I doubt
it.  Of course, a 3 foot section of black pipe would work well, too, and
probably be even cheaper.  You'd just have to design your own end
brackets then.

--
Huw Powell

http://www.humanspeakers.com/audi

http://www.humanthoughts.org/