re. [urq] Dash swap questions + need some parts

[The Loves]

----- Original Message -----
From: "Todd Phenneger" <tquattroguy at yahoo.com>
To: "Eric" <eric_audi.ql at mindspring.com>; "Ben Swann" <benswann at comcast.net>
Cc: <urq at audifans.com>; <Martin at quattro.ca>; <quattro at audifans.com>
Sent: Thursday, December 04, 2003 4:03 AM
Subject: Re: re. [urq] Dash swap questions + need some parts


> Alternatively you can put a 3-gauge pod from a >4ks FWD car where
> the diff lock mechanism is and move the diff >locks down to where
> the Coin tray was.  this has space restrains but I >have seen it
> done.

> > I was going to remove the ash tray (I use it for >>the same
> > thing) and put
> > a small instrument panel in its place.  I was >>thinking an oil
> > pressure
> > guage and a spot for something else in the >>furture.

I used the 4k pod and made a new switch panel to support the switches,
lighter, volt gauge and actuator knob.
http://www2.localaccess.com/theloves/gauges.JPG

Tom