Broke retaining bolt on cambelt idler pulley on 90 200,

[Phil Payne]

> I've never personally had this happen, but it is apparently a relatively
> common experience if you are not careful with assembly and torque. If you
> try to pull the idler pulley in place with the bolt, you will snap it off.
> You have to seat the pulley assembly before you tighten the bolt.

http://www.isham-research.com/quattro/torque.html#3

See the note at the botoom of the page.

-- 
  Phil Payne
  http://www.isham-research.com
  +44 7785 302 803