Propeller Shaft support bearing fix for 85 4KQ needed

Denis sparkplugvw at hotmail.com
Wed Dec 10 09:00:20 EST 2003


You can use BMW part but i dont know witch one. You can also get from Neapco
something similar, but like BMW you ll have to mod the bracket.

I did mine myself in SS bracket and works good. I listed the material in the
previous emails. I can send the list and pics if you want to.

The previous owner of my 100Q got a bad center support bracket, the bearing
and u-joint  were good so he cut and opened the support and  putted a skidoo
strap as a rubber(with urethan glue for windshield) then he welded the
bracket it worked good. But with my tranny swap i needed another driving
shaft,,, 5000TQ in my case so i dont use the center support,,, in this car..

This job is cheap but it works good and you dont need to rebuilt all the
driving shaft,,,, much cheaper.

By the way remove the CV joint, clean them , change balls, easy to get from
bearing dealer, then grease it .....

Denis

----- Original Message -----
From: <Stpndsmnn at aol.com>
To: <Quattro at Audifans.com>
Sent: Wednesday, December 10, 2003 12:31 AM
Subject: Propeller Shaft support bearing fix for 85 4KQ needed


> I know there has been some discussion about this in the past.  I just
> purchased an 85 4KQ for a new project and it badly neeeds a support
bearing.  If the
> center diff is locked it sounds like the shaft is going to come through
the
> floor..
>
> Isn't there a BMW part that can be used as a replacement???
>
> Thanks for any help
> Matt Kramer
> 83 CGTt donor
> 85 4kq new beast
> _______________________________________________
> quattro mailing list
> quattro at audifans.com
> http://www.audifans.com/mailman/listinfo/quattro
>


More information about the quattro mailing list