quattro digest, Vol 1 #4576 - Rusty, grimy screw removal

[Larry C Leung]

Ron,

On my MC2, the injector cooling shroud is
(or should I say, WAS)
attached to a bracket that is held in place
by one of the valve cover studs (IM side)
and to two screws that attach to the strips
that the valve cover studs pass through that
even out the pressure of those nuts on the
valve cover gasket. I'd say the hardest thing
will be getting under the shroud to get to those
nuts (8mm AIR).

Good Luck,

LL - NY

(p.s. see any other shrouds?)




> Date: Thu, 6 Feb 2003 05:56:30 -0800 (PST)
> From: Ron Wainwright <ron_01056 at yahoo.com>
> Subject: stripped, rusted, grimey screw removal
> To: josh at spiny.com
> Cc: quattro at audifans.com
>
>    Joshua,
>
>   It didn't look like the bracket was seperate,
>  it looks like the bracket (holding the two lower
> screws rite near the fuel injectors)
> is attatched to the block, at least from what I could
> see in a few pix's in the FA.
>  So how's the bracket attatched and where?
> Thanks
> Ron
>