87 5K TQ wagon clutch swap

Louis-Alain Richard laraa at sympatico.ca
Thu Feb 13 18:51:00 EST 2003


<snip>
In order to unscrew it, you have to remove the clutch slave first.  You
will
need a punch that is exactly 6 mm (or was it 8) in order to punch out
the
pin holding the slave in.  But this isn't the end of it, the slave may
very
Stephane
<snip>

...as always, I must add my word: if you don't have a 6 mm punch, just
use the shaft form a worn hatch/trunk lift shock; it is exactly the
correct diameter for the job, BTDT autumn 2001.

Louis-Alain




More information about the quattro mailing list