Exhaust options for Typ 89 10v engine

[JShadzi at aol.com]

--
[ Picked text/plain from multipart/alternative ]
Ditto Jim on the below...also, a good bender can get some really smooth bends
with a mandrel bender (crush type), just have to find someone who knows what
they're doing.

Javad

In a message dated 2/21/2003 6:19:53 PM Pacific Standard Time,
jeg1976 at yahoo.com writes:

> Your best bet is to have a shop custom bend you one
> with 3", or do a 2.5" mandrel system.  Have them order
> a high flow 3" cat and just use a couple of strait
> through ~15" long glass pack mufflers.  Prices can
> vary between $400 - $1000 dollars depending on the #
> of mandrell bends and types of mufflers used.  You can
> do it all with a normal bender, but the area going
> over the axle and the sharp bend to the rear muffler
> should be mandrel I think.  I'm going to have mine
> re-done some day.  Don't get a Stebro, they are not
> really performance exhausts, just nice stainless stock
> replacements IMHO.
>
> HTH,
>
>
> =====
> Jim Green
> '89 90tq 034EFI, Haltech IG5
> http://www.geocities.com/jeg1976/car_home.html
>
>