Autometer A/F gauge

Mike Del Tergo mdeltergo at hotmail.com
Wed Jan 29 13:44:16 EST 2003


Help!

I'm trying to hook up an Autometer A/F gauge to my MAC 11'd Ur-q with not
much success.

Lino,
You are correct, pretty easy wiring job.  BTDT on my UrQ.  I don't think
you'll blow anything as long as you don't put 12V to the sensor signal wire.
  You said you had a funky readout but you didn't say if the 02 input wire
was connected or not.  Do you have a 1 wire 02 or a 3 wire?  MAke sure you
connect to the signal out put of the 02 and not the 12V.  Also it takes a
few seconds for the 02 to heat and register, was the car running when you
got this readout?  I think mine reads 1 led full rich on ingnition.  You
will note the mix jumps around quite a bit and I think it mentions that in
the directions.
regards,
Mike

_________________________________________________________________
MSN 8 helps eliminate e-mail viruses. Get 2 months FREE*.
http://join.msn.com/?page=features/virus




More information about the quattro mailing list