Power steering belt question:

[Kneale Brownson]

At 08:40 PM 07/20/2003 -0400, josh Leonti wrote:
>This is a multi-part message in MIME format.
>--
>[ Picked text/plain from multipart/alternative ]
>Allrighty this is getting me a little frustrated.
>I have an aby motor with a 7a crank pulley.
>It's the same setup as the 7a motor now basically.
>
>I was sent from Blau.. a Conti? 13x992belt
>And then I was sent the same thing From Performance motorsport.
>
>For the life of me I can't get it to fit.. it should be a 12.5x995? I
>believe, but as I type this I am looking at etka and it also says
>12.5x992. Noted ekta also says 12.5x1030 for the aby motor but I have the
>crank pulley from the 7a motor attached now so it shouldn't matter.
>
>I read etka, I check through the bently. At this point I will be going to
>the Stealership with an etka print out and make sure I get the right belt...
>
>But has anyone else have issuse with this same problem?

When I ordered my timing belt "kit" from TPC recently (not yet installed),
Rod had me measure the PS belt because he said there were two length
options for the engine.